+.SH "CONFIGURATION FILE"
+
+The configuration file is a succession of lines, each starting with
+one of the three keywords thermal_files, fan_file or
+temperature_thresholds, followed by the same parameter values as for
+the command line arguments. The default configuration file is located
+at /etc/breezed.conf
+
+.SH "EXAMPLES"
+
+If a configuration file exists, the standard way to start breezed is
+to run it without arguments.
+
+Starting it with all the arguments on the commande line can be done
+for instance with
+
+.P
+.nf
+.B breezed --no-configuration-file \e
+.B \ \ \ \ \ \ \ \ --thermal-files /proc/acpi/thermal_zone/THM0/temperature,/proc/acpi/thermal_zone/THM1/temperature \e
+.B \ \ \ \ \ \ \ \ --fan-file /proc/acpi/ibm/fan \e
+.B \ \ \ \ \ \ \ \ --temperature-thresholds 52,54,56,58,60,62,64,68:full-speed
+
+which specifies that when the temperature raises above 52C, the fan
+level should be 1, when the temperature raises above 54C it should be
+2, etc. The maximum speed level 8 should be chosen for temperatures
+above 68C, and its name is "full-speed" (since no other speed name is
+provided, the other ones are the default level names, hence their
+numerical value).
+
+Due to the two degrees gap between the thresholds to increase and the
+thresholds to decrease the temperature, it will for instance remains
+at speed 1 until the temperature goes down to 50C.
+
+Because it takes into account all the values found in the thermal
+files, you can use as well /proc/acpi/thermal_zone/THM?/temperature or
+/proc/acpi/ibm/thermal.
+
+.SH "AUTHOR"
+.PP
+Written by Francois Fleuret <francois@fleuret.org>. Permission is